Home > Products > MX-29x
 
Demo-Alert（new） - MX-29x

Basic Specification
Operating Voltage 3.7V DC
Stand-by Current ≤2.0mA
Activation Current ≤160mA
Horn Alarm Output ≧85db
Stand-by Battery Life ≧3 days （70mA）
Detecting Cable Ring Type / Curved Surface / Curved Surface + Ring Type
Cable Length 200cm (Coil Version)
Cable Thickness 2.0mm
Main Unit Measurement 48.0*35.0*8.5mm
Induction method Contact Separation alarm or Cable breaks alarm

Introduction
    Nowadays, the Camera, Head-set, Smart-Phone, Tablet has become a favorite target of thieves, once Notebook is stolen; it means that you are lose the hardware. If you are concerned to protect your expensive hardware, you should try to take precautions to secure your property.

Model No.: MX-29C / MX-29R / MX-29TCR
  1. 1. MX-29C (main Unit with Curved Surface Detecting Cable).
  2. 2. MX-29R (main Unit with Ring Type Detecting Cable).
  3. 3. MX-29TCR (main Unit with Twin Detecting Cable (Curved Surface + Ring Type).

Function
    Disconnect alarm function: contacts separated alarm, disconnect alarm.

Features
  1. Signal Target Demo-Alert.
  2. Quick Reaction speed, dis-connect or cut any cable, the alarm warning.
  3. Once the alarm has been triggered, restitution cannot disarm, the alarm must be reset by staff. With higher safety factor, it can protect customer's property.
  4. LED indicator display Demo alert status (Active, Low Power, Charge status).
  5. Built-in rechargeable battery, if battery low.
  6. Built-in horn alarm in main unit, can avoid destruction of the thief.
  7. Wide range Application: retail chain store or exhibition center for Camera, Head-set, Smartphone, Tablet, and other exhibits anti-theft and reusable.

Operating Step
  1. Charge MX-29x 2 hours before use.
  2. MX-29C: Cleaning the surface of the protected product, make sure without dust, water, or organic solvent on the sticker area, the Curved surface stick on the device.
  3. MX-29R: the Ring Type Cable goes through the device Strap hole, and then alarm goes through the Ring Type Cable.
  4. MX-29TCR: the Ring Type Cable goes through the device Strap hole and then alarm and Tag goes through the Ring Type Cable and cleaning the surface of the protected product, makes sure without dust, water, or organic solvent on the sticker area, the Tag stick on the device.
  5. Turn “ON/OFF” slide switch to “ON” position.
  6. Clean the surface adhered by the anti-theft host, make sure without dust, water, or organic solvent on sticker area.
  7. Tear off 3M sticker (Tag) and stick on the device surface. Make sure stick as well.
  8. Once stick on display area, alert in active position.

LED Indicator Status
  1. Blue Indicator (Breath): Active status.
  2. Red Indicator (Breath): Low Power.
  3. Red Indicator (Blinking): in Charge.

Multi Color

and
and